
102 Wi² Controller CLI Reference Guide
Chapter 2 - CLI Commands
2.11 LAN IP Interface Context
Context path: View > Enable > Config > LAN IP interface
This context provides commands for configuring various IP-networking related
settings for the LAN interface.
end
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
end
Switches to parent context.
ip address
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
ip address <ip address>/<mask>
Sets a static IP address for the port.
Parameters
<address> IP address.
</mask> Subnet mask in CIDR format. Specifies the number of
bits in the mask.
ip address management
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
ip address management <ip address>/<mask>
Sets a management IP address for this device.
Parameters
<address> IP address.
</mask> Subnet mask in CIDR format. Specifies the number of
bits in the mask.
passive-interface
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
passive-interface
Sets RIP to operate in passive mode (listen for routing broadcasts to update
the routing table, but do not broadcast own routes).
no passive-interface
Sets RIP to operate in active mode (listen for routing broadcasts to update
the routing table, and also broadcast own routes).
Komentáře k této Příručce